The tool change-slide system 50 is used only CTNE electric and
pneumatic actuators, which brings considerable advantages in the
management cycle and the speed and leads to a marked reduction of the
acoustic and the environment. This benefits the manufacturer Colombo
Filippette shows at the EMO 2011 in Hannover.
The tool-change system consists of a slide changer unit mounted on a
servo motor driven carriage.
The system consists of a changer unit mounted on a servo motor
driven carriage which is displaceable by rolling on a hardened
dovetail. The change cycle (rotation by 180 °) via a precision servo
motor with reduction gearbox, while the Kegelabziehhub is controlled
by a dynamic cylinder.
Tool change-slide system used horizontally and vertically
As explained, the version (OV) to run the AC with the grips both
horizontally and vertically: In this version of the tool changer
mounted at a pivot point and is driven cylinder, tilted by 90 °. The
gripper is mechanically controlled, with locks that come on at the
moment of removing the tool from the chuck.
The unit is equipped with CTNE 50 different ring or wheel bearing
types and can accommodate 20-80 tools, depending on production
requirements. The system is suitable according to the manufacturer for
the following cone-types: ISO 45, ISO 50, BT 50, HSK 80, HSK 100,
Capto C8 and Capto C10, with tool weights up to 25 kg in the standard
version and up to 35 kg in the stronger version.
Colombo Filippetti Torino at EMO Hannover 2011: Hall 13, Stand E30
No comments:
Post a Comment